WOOD SHOP HINGE PLATE BODY CONSTRAINT FITMENT
Document Number: SS99
Author: Thomas Sloan Kirton
Date Created:
Revision Number: v1.0.0
Document Approved by:
NOTE. Document is uncontrolled if printed
All instructions in this manual must be adhered to for this stage. Read all instructions carefully and study the photographs. While learning this procedure, quality of work is more important than speed of assembly.

Take the dash rail assembly and line up both brackets to the holes located within the slotted sections.
Once lined up use x4 m4x20mm countersunk pozi head screws (MGS20010) to fix both brackets in the correct areas.
Mount the dash rail & bracket assembly to the build buck.
Use Image for reference.

Slide the hinge plate into the area shown.
Insert (in places labelled 1) x2 m6x70mm countersunk bolts (U501067), x2 m6 countersunk cup washers (F411002) & x2 m6 serrated nuts (MGN0024).
Insert x4 1mm door shims in the green area and fix the shims/hinge plate with x2 m8x25mm flanged hex bolts (U500064).
Once all fixings area placed, see that the holes for the pozi head screws (found on the reverse side) are in the correct area and tighten in the numbered sequence – 1 then 2.
Repeat process to both sides.
Use image for reference.

Once the hinge plate has been fixed into the correct area, use x2 m4x20mm countersunk pozi head screws (MGS20010) to fix the bracket to the hinge pillar.
Repeat process to both sides.
Use image for reference.